Causes and solutions of adhesion on the surface of printed film rolls
Release time:2024-06-28
Failure causes
(1) Insufficient drying, residual solvent.
Ink surface dry, there is still a large amount of solvent inside, especially the printing plate is deeper, multi-colour overprinting, the amount of ink is large, in a short period of time under the action of strong heat ink surface drying, the formation of a layer of film, the solvent is closed in the interior, resulting in solvent evaporation difficulties, these residual solvents will be re-dissolved inks caused by adhesion. In the printing speed and drying conditions, the solvent ratio does not match the case, easy to cause a lot of solvent residue.
(2) The film itself contains more processing aids, such as plasticisers, slip agents, antistatic agents, anti-oxidants, etc. migrate to the ink film to make it soft, soft PVC, a variety of coated film is particularly easy to produce.
(3) The use of two-liquid reactive ink is not appropriate, such as the amount of curing agent is not appropriate, so that the ink can not be cured, can also cause adhesion.
(4) Insufficient cooling of the film after printing and drying, the residual heat after rewinding softens the ink, movement and frictional heat during rewinding exacerbates this effect.
(5) too much pressure caused by the winding, especially the film with large extensibility, the shrinkage of the winding after cooling makes the core pressure become very large, resulting in adhesion, in the design of a continuous local longitudinal patterns, lines, the formation of continuous winding "ribs", the pressure of the raised parts is very large, easy to stick.
(6) Storage environment temperature is too high, direct sunlight, close to the heat source and the film roll lying horizontally are prone to sticky ink.
(7) Ink adhesion is low, easy to transfer sticky ink.
(8) Gold ink, silver ink printing is easy to dry insufficiently, resulting in sticky ink.
(9) For double-sided corona treatment of materials, such as PE, PA and other materials with high surface tension on both sides, especially pay attention.
Solutions
(1) Keep the drying system in the best condition, drying temperature, air volume, wind speed is appropriate, and with the printing speed to match, fully reduce the residual solvent.
(2) Check whether the cooling roller is in good working condition, so that the film is fully cooled.
(3) Winding tension and winding pressure should be appropriate, if necessary, to reduce the number of winding metres.
(4) Pay attention to the design of the graphic as far as possible not to cumulative overlap.
Contact Us
Contact: Ms Zhang
E-mail: scarlette@jindepack.com
Add: Changxing Road No.2, Xiaonan Economic Development Zone, Xiaogan City,Hubei, China